Essential tools of keeping a car in good repair（part 1）

Essential tools of keeping a car in good repair（part 1）




Auto increasingly become the daily means of transport, to go out driving, it will inevitably encounter problems when the car, for example, broke down, and the battery run out of power, and a flat tire and so forth. This time the owner will need to have a fully equipped emergency kit practical. Then the emergency kit needs to have any tool?



Car emergency tool set includes: folding reflective warning signs, nylon tow rope, tie off Firewire power inverter, cotton work gloves, multifunction flashlight (with batteries), inverter, automotive fuse, to avoid demolition of tire repair tools, waterproof adhesive tape, insulation tape, fire extinguishers, playing an indispensable tool for pump, etc. 11.







1, collapsible reflective warning signs



This collapsible reflective warning signs are very useful, in your car troubles need to stop checking the time, to have it placed 50 meters behind the car outside, reminding passers-by slow down in advance. At the same time, not when the folding type of warning signs on the car will not take up much room.

2, nylon tow rope



Must be prepared to at least be able to drag a 3-ton vehicle with a trailer, so that the car can be easily broken down when towing.



Third, take power over FireWire



Car radio will not boot to use it can be carried out through a separate battery to start the vehicle. Bold's battery start line, the largest by current 200AMP, generally suitable for displacement of less than gasoline engines in the 2500cc or the 2000cc displacement diesel engines within the battery used between.



The use of the process to note:



Two vehicles can not have any contact with the two vehicles electronic system must have the same voltage.

If the battery had frozen, you can not use the battery started firing line of the ride.

Before connecting, two car engine, audio, air-conditioning are required to switch off.

The connection procedure is as follows:

(1) First, the red wire will launch the line clamp in the "rescued car" on the red battery cathode.

(2) and then the other side of the red wire clamp in the "rescue vehicle" on the red battery cathode.

(3) to the black wire clamp in the "rescued car" the black negative battery.

(4) and then put the black wire clamp in the "rescue train" the black negative battery.

(5) first started, "rescue train" engine, and then start the "rescued car" engine. If it is found rescued cars are still unable to start, we must check whether the part being exposed metal contacts.

Upon the completion of the engine, the still need to remove in order to start take the FireWire, or they may cause short circuit.



Wire removal procedures are as follows:

(1) First, the "rescued car" black wire lowered.

(2), then "rescue vehicle" black wire lowered.

(3) and then "rescue train" the red wire lowered.

(4) Finally, the "rescued car" red wire lowered.